Laser Engraving And Cutting Machine & CNC Router Machine Solution
Home ResourcesSample clubWoodwood engrave and cut

wood engrave and cut

BACK TO CLUB
  • wood engrave and cut
  • wood engrave and cut
  • wood engrave and cut
  • wood engrave and cut

Do you wanna send your gifts made by yourself? Morn show you one gift made by laser machine. This Countdown Plaque will make a great addition to your Holiday decorations this Christmas.

MATERIALS NEEDED

    3 - 24" x 24" sheets of 1/4" thick wood

    Spray Paint

    An Morn laser machine

    Start by spray painting both sides of three 24" x 24" pieces of wood. If you spray paint the pieces before you cut them, you won't have any paint residue on the cuts.



Settings

Speed:220mm/s Power:50%

STEPS TO FOLLOW

  • 1

    1. Start by covering an area of 24" x 24" sheet of 1/4" thick mdf

    2.Open the file and send it to your laser using the appropriate settings for cutting 1/4" thick mdf

  • 2

    3. These were setup to work with the 24" x 24" sheets of mdf. If you are working with small pieces of wood, adjust the page size and move the pieces around so that they all fit on the wood.

    4. If you work with a different thickness of wood or resize the pieces to smaller dimensions, you will need to resize the slots so they will fit correctly together.

  • 3

    After the pieces are cut out, it's time to put together the puzzle!


    After the pieces are cut out, it's time to put together the puzzle!


    Start by attaching the tail piece to the hip, then the hip to the back. Next attach the three pieces that make up the head. Use the diagram to the right to help identify each piece.


    Next, put together the legs and the rest of the hip pieces, attaching them to the already assembled portion of the dinosaur.


    For the tail vertebrae, arrange each of the eight pieces from smallest to largest. The smallest piece goes into the slot at the far end of the tail, while the largest piece goes in the slot closest to the legs.


    When you have the tail finished, you can add the back vertebrae. There are six pieces that we will arrange from smallest to largest with the largest piece inserted in the slot closest to the legs and the smallest nearest the head.


    The third vertebrae from the head should be the piece pictured in the blue box to the right. You'll notice that this piece has two additional slots to place the arms

FREESAMPLES

FREESOLUTIONS

© 2016 Morn Technology. All Rights Reserved.Privacy PolicyTerms Of UseSitemapSitemap